著作(論文等)

基本情報

氏名 吉村 敏彦
氏名(カナ) ヨシムラ トシヒコ
氏名(英語) YOSHIMURA Toshihiko
所属 山陽小野田市立山口東京理科大学工学部機械工学科
職名 嘱託教授
researchmap研究者コード
researchmap機関

発表形態

Research paper

掲載年月

2026/10

掲載誌名等

Results in Surfaces and Interfaces

論文名

Surface modification of Ni-based single crystal superalloys by
energy-intensive multifunction cavitation with synchrotron X-ray
irradiation at SPring-8

著者名

Toshihiko Yoshimura, Umi Sugitani, Eito Chikashige, Suguru Ito, Kentaro Uesugi

巻

25

号

101033

開始頁

1

 

~

終了頁

14

出版者(日本語)

Elsevier

出版者(英語)

Amsterdam, Netherlands

概要

Objectives: To investigate the surface modification behavior of Ni-based single-crystal superalloys using a novel processing technique that combines high-brilliance synchrotron X-ray irradiation at SPring-8 with positron- assisted magnetic energy-intensive multifunction cavitation (PXMEI-MFC). The effects of processing pressure and working fluid on surface properties were systematically evaluated.
Methods: Ni-based single-crystal superalloys SC610 and CMSX-4 were treated using PXMEI-MFC under pressures ranging from 5 to 25 MPa. Acetone/deuterated acetone and water/heavy-water mixtures were used as working media. Surface hardness and surface roughness were measured, and microstructural changes were examined by scanning electron microscopy (SEM), energy-dispersive X-ray spectroscopy (EDS), and laser microscopy. Results: Processing with acetone resulted in significant hardness increases of approximately +100 to 150 HV, demonstrating a hardening capability comparable to or greater than that of conventional shot peening. In contrast, water processing increased the hardness of CMSX-4 without a corresponding increase in surface roughness, whereas SC610 exhibited only limited changes. Surface roughness tended to increase under low- pressure conditions and decrease at higher pressures, although these conditions did not always correspond to maximum hardness. SEM and EDS analyses suggested reaction-layer formation at intermediate pressures and uniform plastic deformation at higher pressures.
Conclusions: The surface modification behavior produced by PXMEI-MFC depends strongly on processing pres-sure and working medium. The combined use of synchrotron X-ray irradiation and multifunction cavitation provides simultaneous surface hardening and surface smoothing effects and represents a promising surface modification technique for improving the performance of Ni-based single-crystal superalloys.